Preparing Rustoleum Garage Floor Epoxy

0

Rustoleum garage floor epoxy finish is an epoxy resin which provides a surface coating that protects the floor from stains caused by common brands of gasoline, oil, antifreeze, road salt and tire. The application of Rust-Oleum epoxy coating garage floor begins with a thorough cleaning and etching of the concrete surface.

Instructions to prepare rustoleum garage floor epoxy: remove the baseboards of the perimeter walls of the garage. Sockets set aside for later installation. Sweep the concrete surface to remove all loose dirt. Vacuum the floor surface to remove dirt or debris from the floor. Prepare a number of concrete patch to repair cracks or fissures in the concrete floor, if any. Use a spatula to apply patching compound, then let it heal completely before proceeding to the next step.

Prepare a solution of TSP cleaner. Apply the TSP cleaner all the soil surface and scrub the floor with a floor brush to remove oil, grease and similar surface stains from concrete surface. Rinse the floor and allow it dry completely before proceeding.

Mix a solution of muriatic acid and water in a clean plastic bucket. Spread the acid solution on the soil surface and allow the concrete is saturated for about 15 minutes, then rinse the floor with clean water. Let the entire garage floor surface to dry completely before proceeding with the application of rustoleum garage floor epoxy.

Rustoleum Garage Floor Epoxy Colors

Rustoleum garage floor epoxy – Epoxy is a two-piece polymer used as an adhesive or as a non porous layer. Rustoleum garage floor epoxy is an epoxy that provides a surface coating that protects the soil from common stains caused by gasoline, oil, antifreeze, road salt marks and tire. The application of Rustoleum garage floor epoxy begins with cleaning and pickling of the concrete surface. These procedures ensure a ground duly prepared for the application of epoxy.

The surface of the rustoleum garage floor epoxy pump to clean any dirt or residue of the plant using a shop VAC or a household vacuum. Be sure to open cracks in the surface of the floor to remove dirt for patching vacuum. Prepare a number of concrete patches mixture according to the manufacturer’s instructions for repairing any cracks or fissures in the concrete floor, if applicable. Use a spatula to apply the patch mix, then leave it to cure completely before proceeding to the next step.

Prepare a solution of TSP cleaner according to the manufacturer’s specification. The TSP cleaner is applied to the surface rustoleum garage floor epoxy of the whole plant and scrub the floor with a floor brush to remove oil, grease and similar surface stains from the surface of the concrete. Rinse the floor using a hose and nozzle of the sprayer. Allow the soil surface to dry before continuing.

Comments are closed.